We work in both Microstation V8 and PowerCivil. Within Microstation there is a command that will set an element to an elevation, and then increment up or down to a new elevation. This command is very useful when setting contours to the correct eleveation. The command will not work in Powerstation, is there a command that will set an element to an elevation and then increment to a new elevation?
I received this anwser but I we work in PowerCivil there is no Deisign Surface command. Unless it is lable as something else. Please help?
From the InRoads dialog box select Surface>Design Surface>Set Elevation. Set the Input Mode to Single, key-in the desired elevation at the bottom of the dialog box at Elevation and then select Apply and Identify the element.