Cross Section - Proposed Surface Wider than Cross Section

I am working on cutting cross sections for a new 4 lane roadway.  The standard cross section borders go from 150' left of baseline to 150' right.  Being that this is a new roadway, the  proposed surface sometimes goes beyond these limits, so we'll need a matchline above to show the rest of the section.  Is there some way to do this when cutting them?  Or at least a way to tell the cross section command that if the proposed surface is wider than 150' left or right to only put one section on that sheet so we can add the matchline above it?

MicroStation SS3 V 08.11.09.357 and Inroads SS2 V 08.11.07.566

Thanks!