I’m having some issues with my combined surface on a project. I have a 4 lane mainline with 4 ramps. I have target aliasing on the ramps so that the infield side end condition of the ramp finds the mainline model’s fill slope. This is fine until I flatten the slope of the mainline fill which then extends further than the ramp outside fill slope does.
I went back into the template and changed the end condition on the outside of the ramp to find existing ground instead of the active surface. It now does, at the slope I want, but it then connects from there to where the mainline slope would hit the existing ground.
Is there some way to have the surface stop where the ramp slope hits the ground?
I’m using Selectseries2 V08.11.07.566
Thanks,
Joe