Situation: I have a singular horizontal alignment that has multiple vertical alignments. Each vertical represents a special ditch profile that my end condition template must follow.
I am looking for a way to display all verticals of this given alignment in the default 3d model so that I can verify my ditch template is following these alignments.
Currently the active profile displays in 3d. I can also use the 3d geometry task>Additional 3d by Plan Profile tool to create 3d linears of the additional verticals.
Issue: There are around 20 verticals that need to be displayed. The above noted tool requires me to first pick the horizontal alignment (fine) but then it asks me to pick the vertical (fine if there was only a few but I have over 20 and don’t want to have to do this 20 times). Also, this tool does NOT honor a selection set so I cannot grab them all at once.
I tried to complex the alignments together in to a singular complex element but many of them overlap and, although this could be a valid workflow, I could see potential issues down the line.
Does anyone know of a more streamlined approach to accomplish this?
Marc
Inroads 845