Hi,
Using PowerInroads SS4 (.845)
There are few Overlay/Milling components in our corridor. We cut cross-sections and need to calculate End-Area Volumes.
There is a serious problem with these components. On some cross-sections area of these components is not calculated we will not get area neither printed on CS nor in report. It seems to be random. As a result we get end-area volumes calculations that are worth nothing and are not reliable at all.
Please find dgn with just two cross-sections.
Anyone had similar problem? Any solution? Please, help any tip is welcome.
Another isse but not critical: Milling Component (Stripping Component check box checked in) is not extracted from CUT. As a result cut volume need to be manually redduced by milling volume.
(Please visit the site to view this file)
