youI have a project that I am working on that we created a storm sewer system with the new SUDA technology. But when we went to cut our cross section from the 3D model some of the pipes did not show up in the cross sections. To my understanding it I WYSIWYG (What you see is what you get). Below is a picture of the cross section cut with the pipe missing in-between the inlets.
So I made sure it was visible in the 3D model, which it is as seen below.
But the pipe is shown when I use the temporary corridor view that you get when you select the corridor to view it.
Anybody have any idea why this is happening?