Hello, I’m running the plan and profile generator with some success except for one problem. The first sheet generated is coming up short on the station limits as specified in the length setting. All subsequent sheets are holding the specified length until the last sheet as expected, but the start and end stations are off because of the first sheet station range. I can’t seem to find the source of the problem unless it is how I defined the view layout, location, for plan views. The plan start station is positioning itself where it’s supposed to relative to the border sheet. I have the border lower left corner at absolute xy= 0,0 and the P&P anchor points set relative to that position. The sheet cuts look surprisingly well, all except the first sheet as explained.
I’m stumped.. any ideas?