Heeelp!
I don't understand the utility of the Check Horizontal Integrity tool.
I have a continuous alignment, but made in a non continuous way (because that a engineer does ... I change my mind, I try to improve my solution).
I can’t move further because I have an “integrity problem”.
There is any way to convince the software to rearrange the elements in the logical way ... and not to waste precious time moving the elements in the Check Horiz... window up and down until I find the exact position?
HEEEELP!
(This smart software I’m talking about is Bentley InRoads/RailTrack V08 1.07)