Hello,
I'm trying to do something that should be relatively simple, but there doesn't seem to be a tool or workflow to get it done in Microstation.
Specifically, I want to project two vertical profiles onto a particular element such that it's vertical profile is controlled by changes in either of the first two.
In the picture below, I have the basic layout for a median island. The two crossing lines in the center represent the median's centerline (vertical) and cross slope (horizontal). In some cases, the median cross slope may break at the middle and slope in opposite directions.
What I need to do is to project the cross-slope line profile and the centerline profile onto the remaining geometry. Either project the combination of the profiles onto the end arcs or the connecting tangent lines - it shouldn't matter.
The only way I can get this done otherwise is to use two cross slope lines (each one connecting the ends of the arcs) and eliminate the middle cross slope line.
