OK, I watched some videos, and I understand a LITTLE bit better.
Can I have a hinge point with three different cut end conditions?
I'd like one to just continue down until it exits in the side of an existing ditch.
If there's no ditch to exit into, I'd like one to go up at 3:1 to existing ground.
BUT if there's a special ditch profile, I'd like it to cut a ditch (and back up to XG).
I know I can make a template for each condition, but it sounds almost as if I could do one template with three "conditional" conditions.
Or am I getting ahead of myself?
Thank you.
MaryB