I am running earthwork on a cross section file and I am having issues with some of the undercuts randomly not being read from section to section or sometimes within the same section. This project and file is older and was most likely created before V8i. My existing ground, finished grade, and all my undercuts display correctly before running the earthwork routine through project manager. I managed to narrow the issue down to undercuts that are only connected to other undercuts. I can get the earthwork to run correctly for all undercuts connected to the finished grade. As soon as I add the undercut for my aggregate base (under my pavement and curb undercuts), the undercuts that were previously being read correctly now are randomly (I couldn't find a pattern) being missed in some sections. There is even a section where it read the curb undercut on one side, but not the other. There are no earthwork run errors and there is nothing indicated in the log file that something is wrong other than the random missing undercuts. I am not using corridor modeler or INRoads. I believe that the sections were originally cut using typical section generator. Any ideas?
↧