We use Select Series 2 Storm and Sanitary, sometimes for design and sometimes to generate storm profiles from manually computed structure elevations. On a recent site design I ran into two instances where the pipe I inserted between two structures seems to pick the wrong face on the upstream inlet for the connection point. We generally draw our network of structures and pipes and use the graphics to insert the structures in S&S. This works as a check between what we worked out by hand and S&S and allows us to see if structure sizes and rotations are correct and if we are using the right pipe size. We tell Inroads to show the pipe connection to the inside wall of the inlet and not the center because that is how we have always done our designs manually. Is there a way to force Inroads to connect to the face and not the side of an inlet?
↧