I have tried searching on the forums, discussions, and blogs and can’t find my specific question. I'm in OpenRoads ss4 and running a Terrain analysis and notice if your working units are foot it'll be ft3 and yard it'll be yd3. is there a setting where I can change my "volumes" to always read yd3? Or am I out of luck and always use the working units to set it?
I work in foot and would like this functionality to be separate where I can do Cut/Fill qnty on the fly without xml reports and always changing the working units to potentially forget and change it back.
If there's a forum/discussion already started on this could you please point me in that direction, sorry if this is redundant.
thanks in advance!!