Running Geopak SS4 .872, the keyin corridor reattach promises to be an awesome feature. I don't know if the following is a fault of this tool or some other issue.
Some while ago I created a corridor on an alignment that was ultimately to be only a segment of the overall alignment. Specifically, the complex fillet loop segment of a loop ramp. Because there's multiple template drops I was trying to save the corridor if I can. The two are obviously different because stationing was changed from beginning at 10+00 to beginning at 300+00 instead.
Element information reports that it's based on LOOPSW1 which is just the complex fillet segment. I want it to be based on LOOPSW, of which LOOPSW1 is a constituent element and therefore is not accessible to most tools.
I entered the keyin, DPed the corridor, then DPed the alignment, then reset to select the active profile. It looked like it was working, but after it all finished, I click on the corridor and it still reports that it's based on LOOPSW1 and when I create a new cross section view for the corridor (not the alignment) it begins at station 10+00.
Any ideas?